VS10/VS10N/VS10NV Independent Photoelectric Smoke Fire Detection Alarm

Short Description:

This product is only a customer case product display, not for sale, and for reference only.

Product Detail

Product Tags

Product Introduction

JTY-GF-JBF-VS10/VS10N/VS10NV Independent photoelectric smoke detection alarm (hereinafter referred to as smoke detector) is a new generation of independent photoelectric smoke fire detection alarm developed by Jade Bird Fire Co., Ltd. It is mainly used to detect fires that can produce smoke particles in the early stage of combustion. It is suitable for installation in ordinary residences, villas, ancient buildings, small shopping malls, homes, dance halls and other places, and the best installation position is the center of the ceiling. This product should not be installed in kitchens, bathrooms and other places with dense smoke and moisture, and should avoid being adjacent to fireplaces, vents, etc. In addition, try to stay away from lighting equipment such as neon lights and electronic energy-saving lamps (the safety distance should be greater than 50 cm).

This product is composed of a labyrinth, a control chip and its peripheral circuits. It can monitor smoke in real time and periodically detect the environment. Once the smoke is detected and reaches the preset concentration value, it will alarm immediately.

1.1Product Features

⚫ National CCC compulsory certification product.

⚫ Battery powered, independent installation, no wiring required, easy and quick installation.

⚫ Precise smoke monitoring and intelligent analysis of maze signals ensure its excellent safety performance.

⚫ High-performance maze, effectively reducing equipment false alarms.

⚫ Remote smart alarm (except JTY-GF-JBF-VS10), you can check the status of the device with the mobile phone APP;

⚫ It has various fault alarm functions such as battery undervoltage, device offline (except JTY-GF-JBF-VS10), separation fault (except JTY-GF-JBF-VS10);

⚫ Equipped with fully electronic automatic detection function.

⚫ Rapid response, high-decibel alarm output alarm, alarm sound: greater than 80dB (3m in front) 1.2 Scope of application.

⚫ The smoke detector is installed on the site to detect the smoke in the early stage of the fire on site. After the smoke is detected and reaches the preset value, the fire alarm will sound.

⚫ The application design complies with the national standard GB 50116-2013 "Code for Design of Automatic Fire Alarm System".

⚫ Suitable for installation in ordinary residences, villas, ancient buildings, small shopping malls, homes, dance halls and other places, the best installation position is the center of the ceiling.

performance parameter

Working temperature -10～+55℃

Storage temperature -20～+65℃

Relative humidity ≤95% (no condensation)

Instructions for use

Encoder is used to code the equipment, with address range of 1-79. Up to 6 emergency start and stop buttons can be connected in one bus circuit.

Connect the bus according to the wiring diagram, and use the gas fire extinguishing controller to register this button.

Check whether the registration is successful and whether the equipment operates normally through the gas fire extinguishing controller.

Crush the "press down spray" transparent cover, press the "press down spray" button, and the left red light is on, indicating that the spray start button is pressed.

Crush the "stop" transparent cover, press the "stop" button, and the green light on the right side is on, indicating that the spray stop button is in the pressed state.

Reset after startup: there is a key hole on the left side of the product. Insert the special reset key into the key hole and rotate 45 ° in the direction shown in the figure to reset.